Parameters Setting; Auto Color - Konka Group KDL26BZ31U Service Manual

4.4.2 Adjust white balance. Enter factory menu, select "White Blance" item, enter to the
White Balance Adjust Menu.
Adjust
4.4.3 Adjusting chromaticity coordinates of black and white to fit the requirement.
Cool(9300K)
Normal(7500K)
Warm(6500K)
4.5. Gamma Table Loading
Enter factory menu, select "White Blance" item, and press "OK" to set the value.
4.6 . Burn on
When source is in TV mode, select the item of "Burn On" in factory menu, keep the state for
"On" by pressing "OK" button. After putting on the burning switch, the TV set will be boot up
straightly and keep in the snowflake burning on state if you put on the power supply. Here, the
function that auto power-off after in 15 minutes while no signal input will be invalid. When the
burning on finished, please change the "Burn on" state to "Off".
4.7 . No Signal Time off
Select the item of "No Signal Time off" in factory menu, press "OK" to set the value
(2/5/10/15 minute), the default value is 15 minute.

4.8. Parameters Setting

Select the item of "Parameters Setting" in factory menu, press "OK" to enter Parameters Setting
Menu. Then you can set some value for volume and image features.

4.9 Auto Color

Select the item of "Auto Color" in factory menu, press "OK" to start auto adjust the color.
WBRO 0-100
WBGO 0-100
WBBO 0-100
WBRG 0-100
WBGG 0-100
WBBG 0-100
x=0.283±0.015 , y=0.297±0.015
x=0.299±0.015 , y=0.315±0.015
x=0.313±0.015 , y=0.329±0.015