Compressor Protection Function; After Operation; Maintenance - EUROM AC2401 E User Manual

1. Remove the plug at the bottom of the indoor unit.
2. Connect the supplied drain hose to the bottom of the indoor unit, see
3. Turn the device back on. The device can be used in this way temporarily even with a
defective pump.
Testing your Caravan air conditioner
1. Switch on your Caravan air conditioner.
2. Set Cool setting : <22 °C, the display will show 6 cool indicators.
3. Let the air conditioner cool for 15 minutes.
4. HOLD the Cool button and the display shows the temperature from the outgoing cold-
temperature.
5. Release the Cool button, display shows 5 seconds the temperature from the incoming air.
6. After 5 seconds the display returns to normal function.
If the difference between incoming- and outgoing air is at least 10 °C the air conditioner
function is correct.

Compressor protection function

The compressor protection function gives the compressor a 5-minute delay to protect the
device.

After operation

CAUTION
Do not use the power cable to unplug or carry the device. Do not wind the
power cable too tightly or in sharp corners. Do not wrap the power cable around
the device.
1. Make sure the device is switched off and the plug is removed from the power outlet.
2. Let the device cool down before touching it.
3. Wind the power cable.
4. Drain the water from the indoor-unit

Maintenance

WARNING
Do not perform any repairs or modifications to this device.
Maintenance and repairs must be carried out by a EUROM authorized professional. If the
electric cable and/or electric plug is damaged, it should be replaced by the manufacturer or its
service employee or persons with similar qualifications to prevent risks.
(Figure 20).
Figure 20.
31