Panel Overview - Phil Jones Bass BASS ENGINE 17 Owner's Manual

PANEL OVERVIEW

1 2 3 4 5 6
AC INPUT 100-240V~ 50/60Hz 80W
8 9 10 12 13 14 15 18
7 11
16 17
1. 1/4 Line In Jack
For connec�ng to your E-drum sound module or mixer master output. For sounds in Mono,
connect the L/MONO only.
2. Line In Level Control
To achieve op�mal sound quality, adjust the Line-In input level to match the amplifier's
se�ngs.
3. Auxiliary/Bluetooth level Control& Mode Select
Rota�ng the knob will either increase or reduce the input level for AUX and Bluetooth.
Press the knob to switch to the AUX/BT input mode, and pushing and holding it for over 3
seconds will cancel the Bluetooth pairing.
4. Aux/BT Mode Indicator
Blue light on: Bluetooth.
Green light on: Aux input
Adjust the knob's rota�on to either raise or lower the input level for AUX and Bluetooth.
Press the knob to transi�on into the AUX/BT input mode, and maintain pressure on it for
more than 3 seconds to deac�vate the Bluetooth pairing.
5. Auxiliary Input Jack (3.5mm stereo)
This is a stereo mini-jack capable of receiving signals from iPods, iPads, smartphones, or
music players.
6.Line Out (Stereo)
It will output all signals from Aux, BT, and Input to other amplifiers.
7. Input Jack
This input has a high impedance and is designed for both passive and ac�ve instruments.
8. Input Switch
MUTE: Engages the input stage mute. When switched on, the clip LED will illuminate in green.
ACTIVE: Provides a lower sensi�vity input se�ng for guitars with onboard electronics.
PASSIVE: Offers higher sensi�vity through a high impedance input, designed for passive
instruments.
9. Clip Light
When the power amplifier is overloaded and causes distor�on, the Clip light will illuminate in
red. When the amplifier is muted, the LED will light up in green.
3