Viking C-1000B Technical Practice page 2

I n s t a l l a t i o
I n s t a l l a t i o
A. Mounting
Caution: When warm air comes in contact with cold surfaces, such as outside walls, it causes condensation. To help prevent con-
densation from accumulating inside the W-3000, bring conduit into the bottom of the unit. If this is not possible, drill a 1/4" diameter
hole in the bottom of the plastic rough-in box.
Front View of Plastic
Rough-In Box (included)
Wire knock out
(2) Standard flat head dry wall
(sheet rock) screws (not included)
Important: The W-3000 will NOT mount to a
standard double gang box.
Note: The plastic rough-in box (part # 259576)
may be purchased separately in advance. Go to
www.vikingelectronics.com and click on
"spare parts".
3.25"
5.22"
5.14"
Front View of Optional
2.25"
VE-5x5 (not included)
n
n
2.1"
4.0"
(1) .74" dia
3.0"
Condensation
Drain Hole
Rear View of VE-5x5 (not included)
*
1/8" thick foam gasket (included)
* Note: Peel off paper liner and
adhere gasket to the back of the
faceplate, centering it over the four
corner mounting holes.
5.0" Typical
Push to Call Button
Yellow Call Progress/Nightlight LED
(4) 6-32 X 3/4" stainless steel, flat head,
hexdrive, screws (included)
Condensation Drain Hole
(4) 0.38" diameter (for gooseneck mounting)
(4) 0.2 x 0.43 slots for double gang box
(2) 0.2 x 0.43 slots for single gang box
The optional VE-5x5 Surface Mount Box
3.0" 3.3"
is designed to be surface mounted to a
single gang box, double gang box or VE-
GNP gooseneck pedestal (right).
Need More Information on VE-5x5 or VE-GNP?
?
Call (715) 386-4345 and select 424.
W-3000-EWP shown
with Viking Model
VE-GNP
Gooseneck
Pedestal