Viking BLK-3-EWP Technical Practice page 2

e.g
***
PABX/KSU
C.O. Line
-or-
Electronic devices are susceptible to lightning and power station electrical surges from both the AC outlet and the telephone line.
!
It is recommended that a surge protector be installed to protect against such surges. Contact Panamax at (800) 472-5555 or Electronic
Specialists Inc. at (800) 225-4876.
The gel-filled (water-tight) butt connectors are designed for insulation displacement on 19-26 guage wire with a maximum insulation of 0.082 inch-
es. Cut off bare wire ends prior to terminating.
To increase surge protection, loosen the PCB mounting screw labeled
mounting screw to Earth Ground (grounding rod, water pipe, etc.)
When installing a line powered phone on a low voltage and/or low loop current phone system extension, a
may be required. For more information on the
2
When wires are routed from above, a "drip loop" is recommended to keep water away from the circuit board.
Analog
Station
, retrieve
Viking Electronics, Inc., 1531 Industrial Street, Hudson, WI 54016 (715) 386-8666
* Gel-Filled Butt
Connectors
Red
Green
**** Drip Loop
(as shown) and fasten a wire with spade terminal (included) from the
Rear View of a
1600A Series Phone
.
Ring
Terminal
(included)
** Earth Ground
(optional)
Talk Battery Booster