Panasonic KX-FP200 Operating Instructions Manual page 10

Quick Start
Installation
Connecting the telephone line and the power
outlet
1. Connect the handset and handset cord.
2. Connect the telephone fine cord.
3. Connect the power cord.
oThe unit will print an information list.
Power socket
Connect to
LINE.
Power cord => J => Single telephone line (RJ11C)
Line surge
protector )
=> TJ => Power outlet (120 V, 60 Hz)
Power surge
( protector )
Telephone line cord
Note:
For additional equipment protection, we recommend the use of a surge protector. The following types are
available; TELESPIKE BLOK MODEL TSB (TRIPPE MFG. CO.), SPIKE BLOK MODEL SK6-0 (TRIPPE
MFG. CO.), SUPER MAX (PANAMAX) or MP1 (ITW LINX).
oWhen you operate this product, the power outlet should be near the product and easily accessible.
Automatic dialing mode setting
When the power cord is connected, the unit will start detecting the dialing mode.
Display: | CHECKING LINE
Wait until one of the following messages is displayed.
—lIf your line has touch tone service, the unit will display the following message.
LINE IS TONE
—lf your line has rotary pulse dial service, the unit will display the following message.
LINE IS PULSE
olf you connect the power cord before connecting the telephone line cord, the following messages will be
shown alternately.
CONNECT TEL LINE |<*e>}/} TEL LINE IS OPEN
Connect the telephone line cord.
olf the power cord is disconnected or a power failure occurs, the unit will detect the dialing mode again when
power is restored.
©You can change the diating mode setting manually. See "Setting the dialing mode" on page 46.