Samsung SR-S25NTA Service Manual page 69

13-3) Disassembly of Evaporator of Refrigerator
. 13-2) Disassembly of Evaporator of Freezer )
1. After disassembly of the lamp cover for the
freezer, disconnect wire housing from the
lamp socket.
1. Remove all foods in the refrigerator and
shelves.
Disassemble two purifier covers using(-)
driver or the likes and remove a screw.
2. Detach snaps of the bottom side of the
COVER-EVAP FRONT by inserting(-)
driver into the snaps and rotating it toward
the arrow direction.@©
After detachment of the snaps of the EVAP-
COVER FRONT, disassemble the cover by
pulling it to the front.
2. Disassemble and remove two cap-screws
using(-) driver or the likes.
3. After detachment of the insulating material,
Senso:
i i
s LS Front co
f housi :
3. While holding the bottom of the EVAP x evaporator n
a remove screw of damper cover and
COVER FRONT and drawing it carefully
toward the arrow direction, disassemble
the cover by sliding it out at the raised
spot.( @ Since the housing for the thermal-
sensor is located at the rear side of the
cover, be careful during disassembly and
disconnect the housing.)
disassemble by pulling it to the front.
(*While disassembling the damper cover, at
first disassemble the sensor housing at the
left top.)
4. Disassemble the COVER-EVAP REAR by
deatching the snaps and pulling it out to
the front using(-) driver or the likes.
Wie terminal
if 7ER-
Coss ipaieial| ibe erate . me 7 =
5. Disassemble the motor and heater housing
abot eid is ees : ¥ paring it from the wire terminal at the top side of the
out to the front using(-) driver or the Rear cover of
A : evaporator cover.
likes.( @ Slide the cover out by pushing the
held part toward the arrow direction ©
and drawing it to the front @)
y