Samsung SR-S25NTA Service Manual page 119

10. Check the amount of supplied-water to the ice maker.
1) Remove the upper ice maker
frome the refrigerator.
CHECK OF THE SUPPLIED WATER
al.
{The Method to control the amount of water supply to the ice maker)
1. Disassemble the PCB panel at the top of he refrigerator.
CROSS DRIVER(+)
STRAIGHT DRIVER(-)
2. Using the water controlling SM, control the amount of water supply.
= Option to control water-supply time
SWITCH NO
SR-S24FTA
<—
| ON | OFF | OFF | 5 Seconds * The amount of water supply depends upon
7 Seconds the set time and the water pressure(water
- pressure for home use). :
* If th ice cube is small, it may be caused by
less supply of water. So, increase the water-
: | OFF | OFF | ON | cape ass example : change the time
from 6 seconds to 7 seconds).
* If ice cubes are attached each other because
of over-supply of water, decrease the
".water-supply time(for example : change the
time from 6 seconds to 5 seconds).
power switch of the refrigerator must be
turned off and then turned on again.
(Otherwise, the change will not work.)
* When the refrigerator is marketed, the
water-supply time is set to 6 seconds.
Switch ON
Switch OFF
Notice
a8
MODEL NAME | * After change of the water-supply time, the ©
3. If S/W control is completed, check the amount of supplied water to the
Ice Maker.
CHECK OF THE AMOUNT OF
WATER SUPPL'
* If the controlled amount of water supply is slightly below
the optimum level, it doesn't matter for use.
4. If the amount of water supply is not enough, reset the S/W.
(Read item 2 and 3). If the setting is completed in accordance with water
pressure in the pipe, reassemble the PCB panel.
CROSS DRIVER(+)
'eo
WATER CONTROLLING S/W Yr ~~] When setting the amount of water supply,
; Jo. q do not select the large amount of water
4a UY supply from the beginning. Set step-by-step.
bie (Water can be over flowed)
—118-