Technics SL-D2 Service Manual page 5

SL-D2/K
How to remove the bottom plate (Fig. 5)
1) Remove the head shell and turntable.
2) Secure the tone arm with the arm clamper.
3) Turn
over the set taking care not to damage the dust
cover.
4) Remove the 7 bottom plate setscrews @.
Note)
Be careful not to lose the boss cap attached to
the insulator on the cabinet side.
How to remove the radiating fin (Fig. 6)
1) Remove the bottom board as explained above.
2) Remove the 4 setscrews © of the radiating fin.
3) Remove the 2 setscrews © of the top radiating fin.
| : ; Tonearm
Removal
of drive P.C.B. and automatic mechanism Ses:
i
Ro Plate
' :
7
ae
'§ SE
ss'y
ass y (Fig. 6) Pl S Z is, | Automatic
1) Remove the bottom board.
= Ne Ww
ee ec at
2) Remove the speed change knob.
| 8 om Ws
_ \
3) Remove the 4 setscrews ® of the automatic mechanism
ass'y.
Note) 1. Pull the start plate in the direction of the
arrow @ because it may otherwise come in
touch with the tone arm fixing plate ass'y.
2. Since the neon cover is fixed being in contact
with the drive P.C.B. take care not to lose the
Soldered
Removal of stater coil (Fig. 7)
1) Remove the 3 setscrews of the stator cover of the
removed drive P.C.B..
2) Disconnect the 18 soldered parts of the stater coil.
3) Remove the 3 setscrews @ of the stator coil and P.C.B.
board.
Then, the stater coil can be removed. When installing,
position the stater coil as shown by the arrow @.
Soldered
Precautions for assembly
1) Temporarily secure the 3 setscrews of the stator coil.
2)
Secure the automatic mechanism
ass'y with 4 setscrews.
(Pull the actuating plate ass'y in the direction of the
with 4 setscrews.