ViewSonic VPW4200 User Manual page 8

Use only the correct power outlet.
Incorrect power supply could result in fire or electrical shock. Use the correct power outlet depending on the indication on the
display and the safety s tandard.
• The enclosed power cord must be used depending on the power outlet to be used.
SAFETY INSTRUCTIONS (continued)
WARNING
Be cautious of the power cord connection.
Incorrect connection of the power cord could result in fire or electrical shock.
• Do not touch the power cord with a wet hand.
• Check that the connecting portion of the power cord is clean (with no dust), before using. Use a soft and dry cloth to clean the
power plug.
• Insert the power plug into a power outlet firmly. Avoid using a loose, unsound outlet or contact failure.
• Do not cut off the fitted power plug, the removal of which could lead to impaired performance. If you wish to extend the lead,
obtain an appropriate extension lead or consult your dealer.
Be sure to ground the connection properly.
• Connect the ground terminal of the AC inlet of this display with th e ground terminal provided at the power outlet using the
enclosed power cord. If the provided plug does not fit your outlet, consult an electrician for replacement of the obsolete outlet.
Be careful when handling the power cord and external connection cables.
Do not use damaged power cords or cables as they can cause a fire or electrical shock. Do not apply excessive heat, pressure or
tension to the power cord and cables.
If the power cord or cables are damaged (exposed or broken core wires, etc.), contact your dealer.
• Do not place the display or othe r heavy objects on the power cord and cables. Also, do not place a spread, cover, etc., over them
as this could result in the inadvertent placing of heavy objects on the concealed power cord or cables.
• Do not pull the power cord and cables. When connecting and disconnecting the power cord or cables, do it with your hand
holding the plug or connector.
• Do not place the power cord near a heater.
• Do not touch the power plug just after disconnecting it from the power outlet. The static discharge can cause an electric shock.
• Do not touch the power plug during a lightning storm.
• Avoid coiling the power cord and bending it sharply.
• Protect the power cord from being walked on or pinched at particularly at plugs, conveniences receptacles, and at the point
where they exit from the panel.
• Do not modify the power cord.
Be careful when handling the batteries of the remote control.
Incorrect handling of the batteries could result in a fire or personal injury. The batteries may explode if not handled properly.
• Keep the batteries away from children and pets. If swallowed, consult a physician immediately for emergency treatment.
• Do not allow the batteries to be exposed to fire or water.
• Avoid fire or high-temperature environments.
• Do not hold the batteries with metallic tweezers.
• Keep the batteries in a dark, cool and dry place.
• Do not short circuit the batteries.
• Do not recharge, disassemble or solder the batteries.
• Do not physically impact the batteries.
• Use only the batteries specified in the manual accompanying this display.
• Make sure the plus and minus terminals are correct ly aligned when inserting the batteries.
• If you observe a leakage of the batteries, wipe out the liquid and then replace the batteries. If you spill the liquid on your body or
clothes, rinse well with water.
• Obey the local laws when disposing the batteries.
ViewSonic VPW4200/4210
Surely connect
the ground wire.
6