Charging The Battery - Hisense F10 User Manual

Charging the Battery

Charging Battery
1. Insert the large end of the USB cable into the mobile
phone charger and insert the small end into the mobile
phone USB slot, while paying attention to the direction.
2. Insert the charger into a 100~240V 50/60Hz outlet to
start charging.
3. After the battery is fully charged, remove the USB from
your mobile phone and then unplug the charger from
the power outlet.
Charging time
1. If the AC power supply is of a lower voltage, then a
longer charging time may be needed;
2. The charging time will depend upon the current status
of the battery capacity;
3. If non-standard chargers such as computers are used
for charging, then a longer charge time may be
needed;
4. Using the mobile phone while it's charging will extend
its charging time.
Notes:
1. This product is built-in battery, the purchase is already
installed battery, do not disassemble!
2. Please fully charge the battery before first using the
phone and disconnect the charger immediately after
the first charge is completed.
3. Please remove the charger from the AC power socket
when not charging the phone.
4. The phone may not boot immediately if charging with
low battery. After a period of charging, the phone will
boot normally.
5. The mobile phone can be safely charged within the
environment temperature of 0 ℃ to 40
temperatures below 0 o r higher than 40
℃
the battery performance and shorten its life. Long-term
charging in extreme temperatures will mean the battery
is permanently undercharged or damaged.
6. The charger is important for safety, so please use the
special charger for this product and pay attention to
safety instructions during operation.
10
℃ . Charging at
, will harm
℃