Table of Contents
Advertisement
4, Composer
@ In the Track Select section, press the Track Select button(s) (-RHYTHM) - CUPPER)) corresponding
to the track(s) you want to record on.
The Composer provides a selection of four tracks, each with its own Part (P74). Select the track
(s) for the part(s) you want to record.
Performance data produced when playing Manual Drums/Manual Sound Effects and tempo change data.
The Arranger's performance data.
Performance data produced when playing the Lower Part and/ orM. Bass Part.
-—-—~ Performance data produced when playing the Upper Part.
alse
TRACK
) Immediately after pressing (REC), any track can be made the target for recording by pressing the
relevant Track Select button (one that is not already lit), and getting its indicator to start flashing. Pressing
the same button a second time tums its indicator off, which means that recording will not take place on
that track.
With each press of the button, the indicator is either turned off, or will begin flashing.
) If immediately after pressing REC)
there are Track Select buttons that are lit, this means that there is
data already recorded on those tracks.
Pressing any such buttons will cause the indicator to start flashing, showing that you can go ahead and
re-record on that track (using "Replace" or "Mix" recording). If you press it one more time, the indicator
goes out, meaning that the track will thereafter be muted (will not sound) during multi-track recording.
With each press of a button, the indication changes :
Flashing -+-*+-++- Track is targeted for recording,
Off
see
+++-Track onto which nothing will be recorded.
[ilerteneete sees ee Track has already been recorded.
(4) Adjust the tempo with the Tempo Slider or the (INC )//( DEC ) buttons.
You can check the tempo by monitoring the each flash of the Beat Indicator.
©) Start recording. If the Arranger track was selected in step G) , the recording can be staried in one of five
ways (If not, you can start recording by pressing (PLAY }) :
©) Press (PLAY _
() Press (START/STOP }
(>) Press
INTRO
©) Press (SYNC START ) and then a key in the chord recognition area of the keyboard.
©) Press INTRO) + (SYNC START) and then a key in the chord recognition area of the keyboard.
| Press
(PLAY } and recording will start immediately following the two measure Count-in phrase.
ie
Advertisement
Table of Contents
