Peripheral Configuration - Geniatech DB-G2L-V2 Hardware Manual

ISU：Maximum input image resolution: 5M (2800×2047)，Maximum output image resolution: Full HD (1920×1080)，
support color format conversion: RGB / ARGB / YcbCr422 / YcbCr420 / RAW(Grayscale)
16/32GB eMMC
ROM
128Mb SPI FLASH
RAM 2GB DDR4

2.4 Peripheral Configuration

The main peripheral configurations and performance parameters are shown in the following table.
Peripheral Interface Quantities
MIPI CSI
MIPI DSI
DVP
USB HOST
USB OTG
WiFi
Ethernet
4G
Micro SD
CAN FD
SPK
LINE OUT+MIC IN
MIC
JTAG
RTC
Room 02-04, 10/F, Block A, Building 8, Shenzhen International Innovation Valley, Dashi Road, Nanshan District, Shenzhen, Guangdong, China
Emai: support@geniatech.com
1
1x CAMERA，30pin FFC connector, 0.5mm spacing
1x MIPI LCD, 40pin（display）FCC connector + 6pin（capacitive touch screen）FFC
1
connector, 0.5mm spacing, Maximum resolution support up to 1920 x 1080@60fps
1 1x 40Pin FFC connector with 0.5mm spacing, supports WXGA（1280 × 800）60fps
1 USB 2.0 Type A（supports up to 480 Mbps）
1 USB 2.0 Type A（supports up to 480 Mbps）
USB WiFi, 4pin Black Terminal Block, 2.0mm Pitch
1 Note: After the USB_B bus expands four signals through the USB2.0 HUB, one of the
expansion signals The signal is then expanded through the USB2.0 HUB.
2x RJ45 interfaces, RMII/RGMII support, 10/100/1000Mbps network adaptive;
2
The first Ethernet supports PoE PD.
1 Mini PCIe interface via USB2.0 HUB
1 Micro SD card slot
2 2x 4 pin white terminal blocks, 2.0mm spacing
1 4 pin white terminal blocks, 2.0mm spacing
1 3.5mm Audio holder
1 2 pin white terminal blocks, 2.0mm spacing
1 Supports JTAG debugging interface
1 Suitable for button cell MS621 (3V rechargeable)
Tel: (+ 86) 755 86028588
Performance Parameters
6