Advertisement
RC-QN1/QN2/QN3
SOUND
bnbeephiswese the. Unit. On
OA
On
(\
or
staat
The POWER ON indicator (green) lights up and the display comes
on.
The Unit comes on ready to continue in the mode it was in when the
power was last turned off.
ME For example, if the last thing you were doing was listening to.a'
CD, you are now ready to listen to a CD again. If you wish, you
can change to another source.
HE if you were listening to the Tuner last, the Tuner comes on play-
ing the station it was last set to.
Note: When power is supplied from the batteries, the (/| button
on the Remote Control does not work.
Turning the Unit Standby
Press the ©/|button again.
erating on AC power:
Of
or
The STANDBY indicator lights up and the display is blank.
- When in Standby mode, the Unit continues to a small amount of
power (2.6 W) to run the display.
To switch off the Unit completely, unplug the AC power cord
from the AC outlet.
When
power.is supplied from the batteries: .
When the Unit is turned off with the ©/! button on the Unit (the
(| button on the Remote Control is ineffective), the Standby in-
dicator goes out and the display is blank.
To switch off the Unit completely, remove the batteries from the
Unit.
POWER indicator.
Saws
Ne
STANDBY indicator
on
ft tateercenmome
CH UME control
Turn the VOLUME control on. the Unit to the right or left to in-
crease or decrease the volume level.
CAUTION: DO eee turn on the Unit andor start
first: setting t 3 the VOL-
For private listening
Connect a pair of headphones to the PHONES jack.. No sound
comes out of the speakers.
Be sure to tum down the volume before connecting or putting on
headphones.
The System has the following preset.sound effects. that give you
control over the way your music sounds, so you can tailor it to the
acoustics of your room and the quality of your source.. Test. the
sound effects out to hear how each affects
the music. Note that the
effects work only during playback.
Sound effects
FLAT:
No sound effect.
BEAT:
Boosts low and high frequencies.
POP:
Good for vocal music.
CLEAR:
Fora wide, dynamic stereo sound.
To get an effect, press the SOUND button repeatedly until the
Sound mode you want appears on the display.
Each time you press the SOUND button, the display changes as
shown below:
BEAT >» POP —> CLEAR —> FLAT
To cancel the effect, press the SOUND button until "LAT" ap-
pears on the display
Advertisement
