Table of Contents
Advertisement
5
Use the tilt wheel to select the setting [YES]
if fade in of the device should be possible or
[NO] if not. With the function activated, the
controller automatically creates all necessary
intermediate values for the fade in.
6
Press the button ENTER to memorize your
setting.
• To confirm the memory procedure, all LEDs
of the controller flash three times.
7
Repeat the steps 3, 5 and 6 to configure
further units.
8
After your settings, exit the system settings.
For this, keep the button MENU pressed for
2 seconds.
Copying Device Settings
All DMX values assigned to a light effect unit can
be conveniently copied to another unit. The
adjustment can be made in the system settings.
1
Keep the button MENU pressed for 2
seconds to call the system settings.
2
The display indicates the first menu item
„01.Patch fixture" (otherwise select it with the
pan wheel). Press the button ENTER to
begin with the configuration. The display
indicates "PLEASE SELECT FIXTURE".
3
Keep the number button pressed of the unit
to be copied.
4
In addition, press the number button you
would like to copy the values to. The display
shortly indicates "COPY".
FX:01 COPY FX:02
Fig. 6.5 Copying device settings
3. OPERATION
Switch on the controller with the rear power
switch. The unit is in manual mode and the
display indicates "Manual" in the upper line.
Manual Adjustment of an Illumination
Scene
An illumination scene contains the values of all
control channels including the pan and tilt settings
of the connected light effect units.
1
Press the button FIXTURE.
• The control LED lights.
2
Use the number buttons 1-16 to select the
units to be controlled.
• The corresponding LEDs of the buttons light.
• If a number button is pressed once again,
the corresponding device is
deselected.Instead of selecting each device
individually, devices with consecutive
numbers can be selected simultaneously. For
this, press the first and last number button
simultaneously.
Example: For selecting the devices 1 to 8,
press the number buttons 1 and 8
simultaneously. Thus, all 8 devices will be
selected simultaneously. In the same way, it
is possible to deselect devices again.
CH:02 Val:098
Fig. 7.1 Adjusting DMX values
3
Adjust the desired DMX values (0-255) for
the DMX channels using the sliding
controls and, if necessary, the pan and tilt
wheels.
• As soon as a fader is moved, the display
indicates the number of the control channel in
Manual
Advertisement
Table of Contents
