Table of Contents
Advertisement
Overwriting Channels Manually
During the playback of a chase, it is possible to
overwrite the programmed DMX values with the
sliding controls. This allows for minor adjustments
during a live performance without the need for
reprogramming scenes.
1
Press the button FIXTURE use the number
buttons 1-16 to select the units to be
controlled manually.
2
Adjust the desired DMX values for the DMX
channels using the sliding controls and, if
necessary, the pan and tilt wheels.
3
If necessary, use the button PAGE to switch
between the two channel groups 1-16 (LED
A lights) and 17-32 (LED B lights) and repeat
steps 1 and 2, until the desired values are
assigned to all channels.
Deleting a Chase
Program
Fig. 7.16 Programming mode
1
Call the programming mode. For this, keep
the REC pressed until the LED above the
button lights.
2
Press the button CHASE.
• The control LED lights.
3
Keep the button DEL pressed and select the
chase to be deleted with the number
buttons 1-16.
• The control LEDs of the memory banks
containing data light.
• If necessary, use the button PAGE to switch
between the two channel groups 1-16 (LED
A lights) and 17-32 (LED B lights).
• To confirm the deleting procedure, all LEDs
of the controller flash three time.
4
After the desired chase has been deleted,
switch off the programming mode. For this,
keep the button REC pressed until the LED
above the button lights.
Blackout Function
With the blackout function it is possible to blackout
and illumination scene or chase completely.
Current fadings and chases are not stopped by
the blackout function, they continue "in the dark"
in the meantime.
1
With the button BLACK OUT/DEL this
function is switched on: The LED above the
button flashes and all control channels are
set to the output value zero.
2
By pressing the button BLACK OUT/DEL
again, the function stops: The LED is
extinguished and all channels return to their
pervious output values.
3
In the system settings, is possible define
whether all control channels react to the
button BLACK OUT/DEL or only the dimmer
control channel.
After Use
After the operation, disconnect the mains plug of
the power supply unit from the socket, to prevent
unnecessary power consumption.
Advertisement
Table of Contents
