Table of Contents
Advertisement
This cooker hood can be used to recirculate or extract
contaminated air.
Recirculation Mode
The cooker hood is supplied specified for use in the recir-
culation mode with the charcoal filter fitted.
The contaminated air is cleaned by passing through the
filters and than back into the kitchen.
The activated charcoal filter absorbs odours arising from
cooking. In use it will slowly become saturated in grease
and less effective. The filter normally requires changing
after at least every three months or more frequently if the
hood is used for more than three hours per day.
• Insert the connection extension pieces laterally 14.1
in connec-tion 15.
• Insert the Connector 15 into the Support bracket 7.3
and fix it with a screw.
• Make sure that the outlet of the extension pieces
14.1 is hori-zontally and vertically aligned with the
chimney outlets.
• Connect the air outlet connection 15 to the hood
body outlet using either a flexible or rigid pipe
150 mm, the choice of which is left to the installer.
• Ensure that the activated charcoal filters have been
inserted.
Extraction (Ducted)
The cooker hood is more effective when installed in the
extraction mode (ducted to the outside).
Venting kits may be purchased through your retailer or DIY
store, and must be evacuated through an outside vent of
ø125 (5ins) or ø150mm (6ins).
The ducting used must be manufactured from fire retar-
dent material conforming to the relevant British Standard
or DIN 4102-B1.
When the cooker hood is ducted to the outside the
charcoal filter must be removed.
When installing the ducted version, connect the hood to
the chimney using either a flexible or rigid pipe ø 150 or
125mm, the choice of which is left to the installer.
To install a ø 150
• Fix the pipe in position using sufficient pipe clamps
(not supplied).
To install a ø 120
• To install a ø 120 mm air exhaust connection, insert
the reducer flange 9 .
• Fix the pipe in position using sufficient pipe clamps
(not supplied).
• Remove any activated charcoal filters.
OPERATING INSTRUCTIONS
���
Fitting the Ducting
• To install the Ducting Version of the hood, the optional
ø
Ducting chimney kit must be purchased.
Never do flambé cooking under this cooker
hood.
Take extra care when frying and never leave
frying pans unattended during use, as over-
heated fats and oils can catch fire.
Do not leave naked flames under the c ooker
hood.
Ensure the hood is switched on before using the
hob.
Ensure heating areas on your hob are covered
with pots and pans when using the hob and
cooker hood simultaneously.
Ensure not to damage the charcoal filter when
cleaning or replacing as the activated charcoal
inside is saturated with grease, which will stain if
it comes into contact with clothing or furnishings.
6
����
��
�����
�����
�����
�
Advertisement
Table of Contents
