Table of Contents
Advertisement
Available languages
Available languages
1605A000DG 03-22 7350_7300-PGT 3/21/22 2:20 PM Page 8
devices are securely tightened. Loose adjustment devices
can unexpectedly shift, causing loss of control, loose rotat-
ing components will be violently thrown.
p. Do not run the power tool while carrying it at your side.
Accidental contact with the spinning accessory could snag
your clothing, pulling the accessory into your body.
q. Regularly clean the power tool's air vents. The motor's fan
will draw the dust inside the housing and excessive accu-
mulation of powdered metal may cause electrical hazards.
r.
Do not operate the power tool near flammable materials.
Sparks could ignite these materials.
s. Do not use accessories that require liquid coolants. Using
water or other liquid coolants may result in electrocution or
shock.
t.
Use only in well-ventilated area. Working in a safe environ-
ment reduces risk of injury.
u. Allow for sufficient space, at least 6", between your hand
and the spinning bit. Do not reach in the area of the spin-
ning bit. The proximity of the spinning bit to your hand may
not always be obvious.
v. Do not touch the bit or collet after use. After use the bit
and collet are too hot to be touched by bare hands.
w. Do not alter or misuse tool. Any alteration or modification
is a misuse and may result in serious personal injury.
x. This product is not intended for use as a dental drill, in
human or veterinary medical applications. Serious injury
may result.
Kickback and Related Warnings
Kickback is a sudden reaction to a pinched or snagged rotating
wheel, backing pad, brush or any other accessory. Pinching or
snagging causes rapid stalling of the rotating accessory which
in turn causes the uncontrolled power tool to be forced in the
direction opposite of the accessory's rotation.
For example, if an abrasive wheel is snagged or pinched by the
workpiece, the edge of the wheel that is entering into the
pinch point can dig into the surface of the material causing the
wheel to climb out or kickout. The wheel may either jump
toward or away from the operator, depending on direction of
the wheel's movement at the point of pinching. Abrasive
wheels may also break under these conditions.
Kickback is the result of power tool misuse and/or incorrect
8
Advertisement
Table of Contents
