Additional Safety Warnings - Dremel 6700 Operating/Safety Instructions Manual

DM 1619PA7491_06-14_6700 6/26/14 11:46 AM Page 4
Disconnect power from tool before
changing guide
adjustments. Such preventive safety
measures reduce the risk of starting the tool.
Do not operate tool without guide in place.
Slide guide down the slot until it is secured
by the guide latch. Operating tool without
guide can cause personal injuries.
Always wear eye protection. Using
protective equipments will reduce the risk of
personal injuries.
Keep hands away from sharp edge of
workpiece. The workpiece sharp edge may
create a laceration hazard.
Keep hands away from sharpening wheel.
Sharpening wheel can cause personal injuries.
Always hold workpiece firmly with both
hands for maximum control. Keep proper
footing and balance at all times. This
enables better control of the workpiece in
unexpected situations.
Do not operate tool with cracked or
damaged wheel. Replace it immediately by
sending tool to authorized service center
"READ ALL INSTRUCTIONS" — Failure to follow the SAFETY RULES identified
W RNING
by BULLET (•) symbol listed BELOW and other safety precautions, may result in
serious personal injury.
• THINK SAFETY!
COMBINATION
COMMON SENSE, KNOWLEDGE OF THE
SAFETY
INSTRUCTIONS AND ALERTNESS AT ALL
TIMES WHEN THE MITER SAW IS BEING
USED.
Some dust created by
W RNING
power sanding, sawing,
grinding, drilling, and other construction
activities contains chemicals known to
cause cancer, birth defects or other
reproductive harm. Some examples of
these chemicals are:
Safety Rules for Sharpener Station
or making

Additional Safety Warnings

SAFETY IS
OF OPERATOR'S
AND OPERATING
for repair. Operating tool with damaged wheel
any can cause serious injury.
Sharpening wheel is not user replaceable.
Do not attempt to replace it yourself. Send
tool to authorized service center for repair
when the sharpening wheel has reached
end of life. Replacing the sharpening wheel
yourself may damage the insulating flange and
cause an electric shock.
periodically remove the guides and clean
metal dust from enclosure and guides.
Preventive maintenance and properly
operating tool will reduce the risk of electric
shock.
When cleaning do not combine hot metal
dust with combustible materials. The hot
metal dust may ignite combustible materials
and cause a fire hazard.
Do not use dust extraction for operations
where dust may include burning, smoking
or smoldering items like hot metal dust or
sparks. Fire inside the vacuum tank or bag
may occur. Dust may smolder and set vacuum
on fire long after work is completed.
A • Lead from lead-based paints,
• Crystalline silica from bricks and cement and
other masonry products, and
• Arsenic and chromium from chemically
treated lumber.
Your risk from these exposures varies,
depending on how often you do this type of
work. To reduce your exposure to these
chemicals: work in a well ventilated area, and
work with approved safety equipment, such as
those dust masks that are specially designed
to filter out microscopic particles.
4