Table of Contents
Advertisement
2.
Remove the plastic plug and screw (1), and then remove the 2 Phillips M2x5.0 screws (2) and the 8
M2.5x6.0 screws (3).
NOTE:
There are three internal clips by the battery area. Carefully disengage those clips as you are
removing the base enclosure.
3.
Slide a nylon flake tool around the edge of the base enclosure to loosen it, taking care not to damage
the internal clips. Lift the front edge (1) to access the internal clips in the battery area.
4.
Remove the base enclosure (2).
Reverse this procedure to replace the base enclosure.
Component replacement procedures
33
Advertisement
Table of Contents
