Installation Requirements - Ubiquiti US-24-500W Quick Start Manual

Back Panel
Mounting Holes
CONSOLE
Console
Port
Console
Note: There are fans and ventilation holes on the sides of
the UniFi Switch.

Installation Requirements

• Phillips screwdriver
• Standard‑sized, 19" wide rack with a minimum of 1U height
available
• For indoor applications, use Category 5 (or above) UTP
cabling approved for indoor use.
• For outdoor applications, shielded Category 5 (or above)
cabling should be used for all wired Ethernet connections
and should be grounded through the AC ground of the
power supply.
We recommend that you protect your outdoor networks
from the most brutal environments and devastating ESD
attacks with industrial‑grade shielded Ethernet cable,
TOUGHCable
visit: www.ubnt.com/toughcable
Note:
the UniFi Switch itself should be housed inside a
protective enclosure.
Description
RJ45 serial console port for Command
Line Interface (CLI) management. Use an
RJ45‑to‑DB9, serial console cable, also
known as a rollover cable, to connect
the Console port to your computer. Then
configure the following settings as needed:
• Baud rate 115200
• Data bits 8
• Parity NONE
• Stop bits 1
• Flow control NONE
, from Ubiquiti Networks. For more details,
™
Although the cabling can be located outdoors,
Mounting Holes
Power