Table of Contents
Advertisement
7.2
Digital Adjustment
Betore Starting Adjstment:
When EEPROM or the VCA circuit board is replaced, initialize the EEPROM, referring to "Data Initialize" then perform
all the digital adjustments.
1) Start the MAP.
2) Refer to display 1-6.
3) Press B key.
4) Refer to display 3-1.
5) Select the number of the required adjustment.
Notes: « If [ESC] (escape) is pressed, the computer's display returns toMAIN MENU display.
¢ To complete adjustment, press the [ESC] (escape) twice to restore the MS-DOS screen and then turn off the
camera/recorder and jig.
(1) Auto Iris Control Adjustment
Purpose:
To set the iris control data.
Incompleted Phenomenon:
The picture becomes too bright.
The picture becomes too dark.
Condition:
Point the camera at the light box without a chart to full the screen (at wide-angle).
Procedure:
1) Refer to display 3-1.
2).Press 1 key.
Perform adjustment according to the computer display hereafter.
See "8. Error Messages" if an error message appears on the computer display.
3) Refer to display 3-2.
4) Press any key to return to ADJUSTMENT MENU display.
5) Turn the power off for 5 seconds and then on again.
———
Display & Figs
Display 1-6
Display 3-1
Display 3-2
MAIN MENU
.
ABJUSTMENT MENU
.
ADJUSTMENT FINISHED
KIRKE
RIK IIK
ERE
EKER
IKI
HE KEKE
RERRERERR EERIE
RRRREKK
RE KEKE
IKIKES
KEREREREEEE
ERE
EERE
PRESS
ANY
KEY
MANUAL ADJUSTMENT PROGRAM
ADJUSTMENT
[A]
DATA MAINTENANCE
[1]
AUTO IRIS CONTROL
[B]
ADJUSTMENT
[2]
WHITE BALANCE
{Cj
AUTO FOCUS
[3]
CHROMA GAIN
[D]
VCR ADJUSTMENT
[ESC]
RETURN TO MAIN MENU
[E]
STABILIZER
L
Please select [1]- [3] or [ESC]
)
[F]
SPOT NOISE
[{G]
LCD
[H]
COLOR EVF
[ESC]
END
Please select [A] - [H] or [ESC]
E3 - 7
Advertisement
Table of Contents
