Fisher & Paykel RS90AU Installation Manual page 34

Attach the Custom door panels
Tools
Hex key
FPA spanner
(1)
1
Cross-head screwdriver
Powered driver (optional)
2
34
DOOR PANEL INSTALLATION — CUSTOM
Open the door and loosen the M5x10
cross-head screws (do not remove) at
the sides of the doors
Hang the door panel by lowering the
holes of the hanging bracket onto the
M8 studs.
Slide the forks of the side brackets
onto the screws of the door.
Tighten the screws loosely to
temporarily secure the door panel.
3
Loosely screw the M8 washer and
nut to the stud using the hex key and
spanner.
This will allow opening the door
z
without affecting adjustment of
the door panel.