FDS MLED-3C User Manual page 3

MLED-CTRL Box
The user can choose between Time, Date and Temperature or a mix of all 3 options scrolling
consecutively depending on the user selection.
Temperature can be displayed in either °C or °F.
During initial power up, the displays internal time is used. If GPS is selected as the default
synchro source in the settings, once a valid GPS signal is locked the information displayed is
synchronized accurately.
Time of day is put on hold when a pulse on input 2 (radio or ext) is received.
TOD at Input 2 pulse is also send to RS232 and printed.
2.3. Start-Finish Mode
Start-Finish mode is a simple yet accurate mode of displaying time taken between 2 positions
or inputs. This mode works either with the external Jack inputs 1 & 2 (wired solution), or
with WIRC (wireless photocells) signal.
Two input sequence modes are available:
a) Sequenced mode (Normal)
- On receiving an impulse on jack input 1 or wirelessly via WIRC 1, the running time
starts.
- On receiving an impulse on jack input 2 or wirelessly via WIRC 2, the time taken is
displayed.
b) No sequenced mode (Any Inputs)
- Starts and Finish actions are triggered by any Inputs or WIRC.
Besides Start/Finish impulse acquisition, jack inputs 1 & 2 have two other alternate functions
when using Radio inputs:
Alternate Function
- The Result is displayed for a predefined duration (or permanently) as per the user selected
parameter.
- Jack and Radio Inputs 1&2 lock time (delay time frame) can be changed.
- WIRC wireless photocells 1 & 2 can be paired to MLED-CTRL using the Menu buttons or via
our setup Apps.
- The running time / time taken can be any color pre-defined by the user.
December 2021 - Version EN 1.2
www.fdstiming.com
Short pulse
Block/UnBlock
1
WIRC 1 or 2 Impulses
Block/UnBlock
2
WIRC 1 and 2 Impulses
User manual
Long pulse
Reset sequence
Reset sequence