AUTOFRY Model MTI-5 Operator's Manual
Nature of Warranty
This equipment is warranted to be free of
manufacturing defects in workmanship and
materials of construction for one (1) full year
beginning from the date of original retail purchase
and subject to the limitations set forth below. The
controls package consisting of the main circuit
board and keypad are warranted for three (3)
years (parts only, excludes labor). Any part found
to be defective during the warranty period will be
replaced with new or rebuilt replacement parts
free of charge by Motion Technology, Inc. (MTI).
Shipping charges are the responsibility of the
purchaser. Service labor is included for a period
of one (1) full year beginning from the date of
original retail purchase when performed by an
authorized MTI service company or designated
agent based on straight time rates for work
performed during normal working hours. This
labor coverage is limited to a fifty (50) mile radius
(each way) and/or 1 hour travel time to a
customers location. Any and all other service
travel charges will be the responsibility of the
customer.
Scope of Warranty
This warranty is extended to the original
purchaser for products purchased and retained in
the 50 states of the U.S.A. and District of
Columbia. This warranty shall not be effective
unless the equipment was purchased from a
dealer or other person authorized by MTI to sell
its equipment and is not transferable.
The attached warranty registration card must be
fully completed and mailed within ten (10) days of
receipt to assure the validity of this limited
warranty.
Exclusions from Coverage of the Warranty
This warranty does not cover any damage to the
equipment resulting from accident, misuse, abuse
or negligence, failure to follow operating, cleaning
and periodic maintenance instructions, mis-
handling, alteration, failure to install in strict
conformity with local fire and building codes and
regulations, ordinary wear and tear resulting from
use, failure to change filters using only
manufacturers' supplied at the recommended
intervals, or if the installation does not comply
with set-up and installation instructions or any
other circumstance beyond the control of MTI.
MTI-5 OM 6/15 Rev B
Motion Technology, Inc.
Limited Warranty
The equipment shall not have been previously
altered, repaired or serviced by anyone other than
a service facility authorized by MTI to render such
service.
How to Obtain Service
Notification of a defect in the material or
workmanship of the equipment, shall be to the
MTI Factory Service department at the number
shown below or the dealer from whom you
purchased the equipment. We want you to be a
satisfied customer. If a problem does come up
that cannot be resolved to your satisfaction,
please let us know. Write to Service Manager,
Motion Technology, Inc. 10 Forbes Road,
Northborough, MA. 01532. Please be sure to
include the Model Number, Serial Number and
the date of original purchase.
Exclusion of Incidental or Consequential
Damage
Repair or replacement under this warranty is the
purchasers sole and exclusive remedy. Neither
MTI nor the dealer from whom you are purchasing
this equipment will be responsible for any and all
incidental or consequential damages, resulting
from the use of the equipment or from breach of
any express or implied warranty on this
equipment. These warranties are in lieu of all
other warranties, express or implied, including,
but not limited to, the implied warranties of
merchantability or fitness for a particular purpose.
Legal Rights of Warranty
Retain this warranty. It gives the purchaser
specific legal rights. The purchaser may also have
other rights which vary from state to state. MTI
suggests that the dealer's dated bill of sale be
retained as evidence of the date of purchase.
Some states do not allow the exclusion or
limitations on how long an implied warranty lasts,
so the above limitations or exclusions may not
apply to all purchasers.
Technical Service/Support: (800) 348-2976 ext.
112
P/N 63-0006B
3
Need help?
Do you have a question about the AUTOFRY MTI-5 and is the answer not in the manual?