Table of Contents
Advertisement
18
ADJUSTING THE CHAIN TENSION
See page 23. See page 32.
1. Loosen the chain tensioner knob slightly by turning it counterclockwise.
2. To increase the chain tension, turn the chain tensioner adjustment ring clockwise and
check the chain tension frequently. To reduce the chain tension, turn the chain tensioner
adjustment ring counterclockwise and check the chain tension frequently.
3. The chain tension is correct when the gap between the cutter in the chain and the bar is
between 3 mm - 4mm. Pull the chain in the middle of the lower side of the bar downwards
(away from the bar) and measure the distance between the bar and the chain cutters.
4. Tighten the chain tensioner knob by turning it clockwise.
USING THE PRODUCT
ADDING CHAIN LUBRICATING OIL
See page 22.
WARNING
Never work without chain lubricant. If the saw chain is running without lubricant,
guide bar and saw chain can be damaged. It is therefore essential to check the
oil level in the oil level gauge frequently and every time before starting to use the
chain saw.
1. Clear surface around the oil cap to prevent contamination.
2. Unscrew and remove the cap from the oil tank.
3. Pour the oil into the oil tank and monitor the oil level gauge. Ensure that no dirt enters the
oil tank while filling.
4. Put the oil cap back on and tighten it up. Wipe away any spillage.
5. One full oil tank will enable you to use the saw for 20-40 min.
INSTALLING BATTERY PACK
See page 22.
1. Place the battery pack in the chain saw. Align raised ribs on battery pack with grooves in the
chain saw's battery port.
2. Make sure the latch on bottom of the battery pack snaps in place and that battery pack is
fully seated and secure in the chain saw before beginning operation.
HOLDING THE CHAIN SAW
See page 13.
Always hold the chain saw with your right hand at the rear handle and your left hand at the front
Advertisement
Table of Contents
