Table of Contents
Advertisement
UNPACKING
•
Take the products and accessories out of the box carefully. Please verify that all listed articles in
the previous list are present.
•
Carefully inspect the product to make sure it has not been damaged or broken while being
transported.
•
Do not dispose of packaging items until you had the chance to carefully inspect the product and
it has been used satisfactorily.
WARNING
Should there be any damaged or missing parts, please contact GREENCUT's
technical support. Do not use this product without having replaced the damaged
or missing part. Using this product with either damaged or missing parts may cause
serious injuries to the operator.
ASSEMBLY
WARNING
If any parts are damaged or missing do not operate this product until the parts are
replaced. Failure to heed this warning could result in serious personal injury.
ASSEMBLING SAW CHAIN AND GUIDE BAR
See page 30-31.
1. Make sure to remove the battery pack from the unit. Wear protective gloves.
2. Unscrew the chain tensioner knob and remove the sprocket cover.
3. The saw chain should face in the direction of chain rotation. If they face backwards, turn the
loop over.
4. Place the chain drive links into the bar groove.
5. Position the chain so there is a loop at the back of the bar.
6. Hold the chain in position on the bar and place the loop around the drive sprocket. Lower
the bar so that the bolt goes through the hole in the attached chain tension assembly. You
may need to rotate this assembly so the bolt and hole align. You may rotate this assembly
again to apply some tension to the chain which will help keep it in place.
7. Replace the sprocket cover and turn the chain tensioner knob until nearly tight, turn the
chain tension adjustment ring until the saw chain is properly tensioned. The guide bar must
then be pushed upwards, check chain tension again, do not tension the chain too tight.
8. After the chain is well-tensioned, tighten the knob again.
17
EN
Advertisement
Table of Contents
