Pioneer CDJ-2000NXS2 Service Manual page 51

5
Notes on Reassembly
• How to attach the cushion to the shield plate
Shield plate
Cushion
(Wrap the cushion around
the shield plate one round.)
• How to dress the cables between the MAIN and SDCB Assys and between the MAIN and USBA Assys
Shielded
Shielded Conn-Cable (7P)
Conn-Cable (5P)
(Place this cable near
the cable tie.)
CN603
Cable tie
Bind this cable without slack
between the connector and
CN601
the cable tie.
MAIN Assy (back side)
• How to dress the cables from the AC inlet and the SW POWER SUPPLY Assy
The cables from the AC inlet
must be placed at a level lower
than the insulator-mold line.
Insulator-mold
5
6
Press the self-adhesive cushion
against the shield plate so that
the entire area of the cushion is
stuck fast.
SW POWER SUPPLY Assy
Pull the cables
so that they will
not protrude
upward.
Cord clamper
CDJ-2000NXS2
6
7
FFC
Shorter
reinforcing plate 10 mm
FFC
Longer
reinforcing plate
The FFC must be folded at
a right angle downward at the
edge of the reinforcing plate.
Ferrite core
CN1
AC inlet
7
8
SDCB Assy
SDCB Assy USBA Assy
CN5002
CN5102 CN5101
CN604
Cord clamper
After clamping the FFC, bend the end
of the cord clamp at a right angle at a
position approximately 5 mm away from
the end so that it will not come into
contact with the Shielded Conn-Cable.
Pass the cables through the
opening of the chassis.
CN2
SW POWER SUPPLY Assy
8
A
B
C
D
E
F
51