Cisco NCS55A1 Hardware Installation Manual page 60

◦ For sensors 1, 3, and 4 (outlet and onboard sensors), the following actions occur:
◦ Displays system messages.
◦ Sends SNMP notifications (if configured).
◦ Logs environmental alarm event that can be reviewed by running the show alarm command.
◦ For sensor 2 (intake sensor), the following actions occur:
◦ If the threshold is exceeded in a switching card, only that card is shut down.
◦ If the threshold is exceeded in an active route processor card with HA-standby or standby present, only
◦ If you do not have a standby route processor card in your router, you have up to 2 minutes to decrease
Note We recommend that you install dual route processor cards. If you are using a router without dual route processor
cards, Cisco recommends that you immediately replace the fan card if just one fan is not working.
Step 4
show environment power
Example:
sysadmin-vm:0_RP0 #show environment power
Displays the power usage information for the entire router.
Step 5
show environment voltage
Example:
sysadmin-vm:0_RP0 #show environment voltage
Displays the voltage for the entire router.
Step 6 show environment current
Example:
sysadmin-vm:0_RP0 #show environment current
Displays the current environment status.
Step 7 show environment fan
Example:
sysadmin-vm:0_RP0 #show environment fan
Displays the status of the fan trays.
Step 8 hw-module location loc shutdown or [no] hw-module shutdown location loc
Hardware Installation Guide for Cisco NCS 5500 Series Fixed-Port Routers
52
that route processor card is shut down and the standby route processor card takes over.
the temperature. During this interval, the software monitors the temperature every 5 seconds and
continuously sends system messages as configured.
Verify Chassis Installation