Table of Contents
Advertisement
Issue
Display flashes.
UP appears on the
display.
Water is left in the
appliance at the end
of the program.
Appliance cannot be
switched on or oper-
ated.
Appliance does not
start.
Wash cycle starts
up automatically.
Appliance stops dur-
ing the cycle or cuts
out.
Cause and troubleshooting
Appliance door is not closed properly.
Close the appliance door.
▶
Arrange the dishware so that no parts
‒
project beyond the rack and prevent the ap-
pliance door from closing properly.
A software update is available.
Press the remote start button to install the soft-
▶
ware update.
a After a successful software update, "Suc" ap-
pears on the display for a few seconds.
Filter system or area under the filters is blocked.
Clean the Filters → Page 39 .
1.
Clean the Drain pump → Page 53 .
2.
Program has not yet ended.
Wait until the program ends or terminate the
▶
program with Reset.
→ "Terminating the wash cycle", Page 32
▶
Software update is taking place.
Wait until the software update has finished.
▶
Appliance functions have failed.
Pull out the power cord plug or switch off the
1.
breaker.
Wait at least 2 minutes.
2.
Connect the appliance to the power supply.
3.
Switch the appliance on.
4.
The breaker has tripped.
Check the relevant breaker.
▶
Power cord is not inserted.
Check whether the power outlet is working.
1.
Check whether the power cord plug is properly
2.
inserted in the power outlet and on the rear of
the appliance.
Appliance door is not closed properly.
Close the appliance door.
▶
You did not wait until the cycle ended.
→ "Terminating the wash cycle", Page 32
▶
Appliance door is not closed properly.
Close the appliance door.
▶
Power and/or water supply has been interrupted.
Check the power supply.
1.
Check the water supply.
2.
Troubleshooting en-us
51
Advertisement
Table of Contents
