Table of Contents
Advertisement
Issue
Appliance interior
still wet after wash
cycle.
Food remnants on
dishware.
Cause and troubleshooting
Not an error. Condensation drying creates water
droplets in the tub. This is normal. Moisture in the
air condenses on the inside walls of the appli-
ance, runs off, and is pumped out.
No action required.
Dishware was placed too close together or rack is
overfilled.
Arrange dishware with sufficient space in be-
1.
tween.
The spray jets must reach the surfaces of the
dishware.
Avoid points of contact.
2.
Spray arm rotation of the lower spray arm is
blocked.
Arrange dishware so it does not obstruct spray
▶
arm rotation.
Spray arm nozzles are blocked.
Clean the Spray arms → Page 40 .
▶
Filters are dirty.
Clean the filters.
▶
→ "Cleaning filters", Page 39
Filters are inserted incorrectly and/or not en-
gaged.
Insert the filters properly.
1.
→ "Filter system", Page 39
Twist filters into place.
2.
Selected wash cycle is too light.
Select a more intensive wash program.
▶
Dishware has been precleaned too intensively.
Then the sensors choose a lighter cycle. Stub-
born remnants cannot be entirely removed.
Only remove large remnants of food and do not
▶
pre-rinse dishware.
Troubleshooting en-us
45
Advertisement
Table of Contents
