Shifting - Yamaha MT-03 2021 Manual

Operation and important riding points
TIP
This model is equipped with:
a lean angle sensor. This sensor
stops the engine in case of a turn-
over. In this case, the display will
indicate error code 30, but this is
not a malfunction. Turn the main
switch off and then on to clear the
error code. Failing to do so will
prevent the engine from starting
even though the engine will crank
when pushing the start switch.
an engine auto-stop system. The
engine stops automatically if left
idling for 20 minutes. If the engine
stops, simply push the start
switch to restart the engine.
EAU48713

Shifting

6
5
4
1 3
2
N
1
1. Gear positions
2. Shift pedal
Shifting gears lets you control the
amount of engine power available for
starting off, accelerating, climbing hills,
etc.
The gear positions are shown in the il-
lustration.
TIP
To shift the transmission into the neu-
tral position (
down repeatedly until it reaches the
end of its travel, and then slightly raise
it.
NOTICE
Even with the transmission in
the neutral position, do not
coast for long periods of time
with the engine off, and do not
tow the motorcycle for long dis-
tances. The transmission is
properly lubricated only when
the engine is running. Inade-
quate lubrication may damage
the transmission.
Always use the clutch while
changing gears to avoid dam-
aging the engine, transmission,
6-3
EAU16674
2
), press the shift pedal
ECA10261
6