Table of Contents
Advertisement
To bulk receive internal data
important!
* Note that bulk receiving data automatically deletes ail data currently in the memory and replaces it
with the received data. if a problem occurs while data is being received, current settings are
deleted and the WK-1500 is initialized.
* Make sure you do not need the data currently in the memory or save the current settings to an
extemal MIDI device before performing this procedure.
of
ay
—"
aus : - button sequence
Ee
4. Start the bulk send operation on the other MIDI device.
details on how to bulk send data.
* After the bulk receive operation is complete, the WK-1500's display automatically returns
to the
status before you press MIDI button.
Note
9. ASSIGNABLE JACK
The following procedure assigns a function to the assignable jack located on the back
of the
WK-1500.
'
E-82
4
4
4
SUS... sustain pedal
Q
0
Q
SoS ... sostenuto pedal
O
O
OQ
SF... soft pedal
O
's) 0
rHy ... START/STOP button
o
O°0-O
See page E-54 for detail on the assignable jack.
MIDI channel parameter setting
1. TONE
This parameter sets a tone for each MIDI channel.
Note
¢ The WK-1500 allows setting of a value from 0 to 7 for channel 10, which is in accordance with the
shown in the following table.
Channel 10 receive data conversion
Drum Set Name
dr.0 : STANDARD SET
dr.1 : ROOM SET
Drum Set
Received Tone Number
000, 008~015
001, 016~026
002, 024
dr.2 ; GATE SET
003, 025~031
dr.3 : ELECTRONIC SET
004, 032~039
dr.4.: SYNTH SET
005, 040~047
dr.5 : BRUSH SET
006, 048~055
dr.6 : STANDARD SET 2
007, 056~127
dr.7 : VOICE SET
2. VOLUME
This parameter sets the volume of each MIDI channel.
3. PAN
This parameter sets the pan (stereo left/right position during playback) of each MIDI channel.
4. EFFECT SEND
This parameter sets the depth of the effect (REVERB, CHORUS, etc.) of each MIDI channel.
Note
E-83
Advertisement
Table of Contents
