Advertisement
Quick Links
Check batteries, turn on
1
switch to check battery
indicator (battery fully
charged).
4
Install rear squeegee.
Do not over tighten.
Connect the recovery
hose to the squeegee
inlet.
1
Familiarize yourself
with the control panel
and all of its functions
for scrubbing and
transporting.
Focus II Rider How To
Prepare for Use
Select proper brush,
2
inspect then Install
brush (Disc System)
under scrub deck. Align
brush gimbal (push until
it locks).
5
Make sure ball float
system and debris
catch cage is clean.
Machine Operation
2
Press the Solution
Control and Scrub
switch. Adjust the
Solution Control as
needed.
Page: 1
Install pad (Boost
3
System) by first
removing the side skirt.
Line up pad with the
fixed pad drive then
press into place.
6
Fill with water (Below
130° F); add detergent
(follow dilution ration).
3
Begin scrubbing
process.
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Nilfisk-Advance Focus II Rider
Summary of Contents for Nilfisk-Advance Focus II Rider
- Page 1 Focus II Rider How To Prepare for Use Install pad (Boost Select proper brush, Check batteries, turn on System) by first inspect then Install switch to check battery removing the side skirt. brush (Disc System) indicator (battery fully Line up pad with the under scrub deck.
- Page 2 Focus II Rider How To Store the Machine Remove, rinse and Empty and rinse inspect rear squeegee. Remove, rinse and recovery tank, catch inspect brushes or cage and ball float. pads. Empty and rinse Drain water into an solution tank with clean open drain.
Need help?
Do you have a question about the Focus II Rider and is the answer not in the manual?
Questions and answers