Using your unit
Operating Instructions
1. Remove battery and charger from packaging. Ensure
battery is fully charged. Refer to charge level indicatior
table in battery manual for more information.
2. Once fully charged, insert battery into the receiver until
properly secure. Close lid and secure the latch.
NOTE: Keep battery box lid closed and latched unless
accessing battery. Do not operate unit with lid
open or damaged.
3. Verify drain plug is securely closed.
4. Following all instructions from chemical manufacturer,
fill the solution tank with pre-mixed solution.
5. Verify suction line valve at the base of the suction
line is open, allowing fluid into the suction line.
6. Press the power button to turn on the unit.
7. Slowly squeeze trigger handle to begin spraying.
Release trigger handle to stop.
After Use Instructions
NOTE: For proper handling and disposal procedures
refer to chemical SDS.
8. Solution should be removed from unit after each use.
This can be done in two ways:
a. Unthread drain plug from front of tank and drain
solution into an approved location.
b. Place discharge wand into approved container.
Activate unit until all solution has been flushed from
the system.
9. Press power button to turn off unit. Squeeze trigger
handle to relieve remaining pressure.
10. Before using unit with another chemistry, thoroughly
flush with water.
Model: SP-BP-10N
7
4
6
5
2
V20231110 • Page 7 of 8