Foamit SP-BP-10N Operation Manual page 13

If your unit is not operating properly, try using these troubleshooting tips:
Issue
Pump is cycling improperly
The unit operates at a
reduced pressure
Battery will not completely
charge
Battery discharges too quickly
Power button LED slow flashing
Power button LED fast flashing
Battery/charger fault light is
flashing
Model: SP-BP-10N
Troubleshooting Your Unit
• Verify pump did not fail from chemical attack, or electrical malfunction.
• Ensure proper chemical and concentration are being used.
• Verify product is getting to the pump with these steps:
1. Make sure the tank has chemical solution in it.
2. Ensure the suction line valve is open completely.
3. Inspect suction line and strainer for debris or damage.
• If these steps are confirmed, the pump may need to be replaced.
• Inspect suction line and strainer for debris or damage. Clean or replace as
needed. To prevent damage to the unit, the strainer must always be used.
• Inspect discharge hose assembly for build up.
• Place a secondary battery on the charger. If the secondary battery charges as
expected, it indicates that the initial battery is faulty and should be replaced.
• If the problem continues to occur, the charger is bad. Replace battery charger.
• Battery has reached life expectancy. Replace battery.
• Dead battery, charge batttery.
• Compressor startup failure. Reset with a power cycle.
• A faulty pump or compressor may need to be replaced.
• Refer to the separate manuals supplied with the battery and charger for more
information regarding indicator and fault lights.
Solution
V20231025 • Page 5 of 13