Kenwood TS-790A Instruction Manual page 45

OSCAR 13
Uplink frequency . . 435.425~ 435.575 MHz
(LSB)
Downlink frequency ............ 145.975 - 145.825 MHz
i {USB)
i General beacon freq.........-+ 145.812 MHz
| Engineering beacon freg ...... 145.985 MHz
—-— Uplink
~—-—— Downlink
Memory CH Frequency | _ Mode
0 —_|_881.800.0 _| FO-12. JA Mode |
1 _ 581.004.0 | A0-10. B Mode _
2 1706.000.0 __A0-10. L Mode
ENTERING DATA
Determine the uplink and downlink frequencies of the
satellite you are tracking, Add the two frequencies
together. The sum can now be placed in memory as
follows:
1. Press the F key and then the SAT key.
Note:
This function is inoperative when SUB is 'selected.
RECALLING DATA
The satellite memory channels can be recalled in the
following manner.
1. Press the F key and then the SAT key.
Note: -
This function is inoperative when SUB i is selected.
2, Rotate the TUNING knob to select the desired satel-
lite memory channel.
3. Press the SAT key to recall the initial mode setting.
OPERATING PROCEDURE
1. Recall the desired satellite memory channel as
described above.
2. Select the SUB function.
3. Use the TUNING knob to select the desired down-
link (receive) frequency.
4. Press the SAT key. The MAIN display will shift to
the correct uplink frequency.
5. Each time you change the SUB frequency, press the
SAT key twice in order to update the MAIN display.
The first time the SAT key is pressed, the tran-
sceiver goes out of the satellite mode. The second
time it is pressed, the transceiver goes back into
the satellite mode and updates the MAIN display.
An alternative method is to press and hold the SAT
key when going into the satellite mode. While the
key is held, the TUNING knob can be rotated and
both displays will track elmiepeene
Note:
In step 2, the SUB key was pressed to allow the
TUNING knob to control the downlink (receive) fre-
quency. If the MAIN key is pressed, the TUNING
knob will control the uplink (transmit) frequency.
45