Kenwood TS-790A Instruction Manual page 42

4-5-3. Memory Channel Lockout
2. Select the Memory Channel that you want to skip
using the TUNING knob.
3. Press the CLEAR key.
4. A decimal point will appear in the M.CH display to
indicate that the channel will be skipped.
seconds will clear that channel.
4-5-4. Scan Hold
Time operate scanning is selected initially (i.e., scan-
ning stops (for about 5 seconds} when the BUSY in-
dicator lights). You can switch to carrier-operated
scanning (scanning stops when signal is received) by
pressing the TO/CO key during scan.
4-5-5. Priority Alert
When the ALERT function is active the transceiver will
monitor the alert channel every 5 seconds and beep
if the channel is busy (4-4-5. 0. Alert channel).
CALL key. (With the TS-790A).
Press the ALERT key. (With the TS-790E)
The MAIN display will read "'AL''.
Cautions: a e nee oe
1. The alert function does not work when SUB is
selected.
2. The frequency memorized in the call channel
memory will be moved automatically to the alert
channel memory if you initiate the alert function
when no data has been stored in the alert chan-
nel memory.
2. Set the MAIN SQL control at the point where the
noise just disappears.
3. To release the function, press the F key then the
CALL key again. (With the TS-790A}
Press the ALERT key again. (With the TS-790E}
If you press the F-and-CALL key (With the TS-790A),
F-and-ALERT key (With the TS-790E) when the alert
function is on, you will transfer to the alert channel
immediately.
42