Changing The Source - Pioneer KEH-M7300 Owner's Manual

Changing the Source
When the cassette tape is inserted, the source changes at each
press of the button ©: Tape —~ Radio — OFF. When a Multi-Play
CD player — optionally available Multi-Play CD Player CDX-
M40, for example — is connected to your unit, the source
changes: Multi-Play CD Player — Tape — Radio — OFF.
Adjusting Volume/Fader/Bass/ Treble/Bal-
ance
To adjust volume, press the button @. The display changes at
each press of the button @: Volume — Fader — Bass — Treble
— Balance. Press the button @ to adjust the displayed mode.
Adjusting Volume
Pressing the (+) side of button © increases the volume, while
the (-) side decreases it.
Adjusting the Fader
KEH-M6300:
This function controls the balance between the front and rear
speakers of a 4-speaker system. Pressing the (-) side of button
@ shifts the balance to the front speakers, while the (+) side
shifts it to the rear speakers. In the case of a 2-speaker system,
set the display to "F-RO" (or "F-FO").
KEH-M7300:
This faber controls the balance between speakers and [2],
and speakers [3], which are shown in Figure 1 on page 8. Press
the (-) side of button @ to raise the volume of speakers [1} and
only; press the (+) side to raise the volume of speakers
only.
Note:
e The KEH-M7300 has two faders: the electronic preamp fader
and the power fader controlled by fader control knob @. The
use of both faders depend on the way the speakers are con-
nected. For detailes, see "Using the Fader" on page 8.