ZUMEX MULTIFRUIT User Manual page 9

* All these components are dishwasher safe. If pulp has dried on any component, we Detecting Faults and problems
recommend you soak it in water and soap suitable for tableware until the pulp softens,
after which it can be washed in the dishwasher. PROBLEM: The appliance is not working
* Clean the outside of the appliance (motor housing) and the rubber areas that support | Possible cause Solution
the stainless steel tank, using a soft cloth soaked in water and soap suitable for tableware.
* Afterwards, rinse with a damp cloth and clean water to remove all traces of soap.
* When putting the grater-filter back, make sure itis correctly mounted, pushing it down
firmly as far as it will go.
Substitute
* It is recommendated to take appart the grating disk from the filter for an in depth a spare fus
cleaning procedure.
* Itis recommendated to take appart the grating disk from the filter for an in depth
Place the switch in OFF position, wait 5-10
cleaning procedure. To assemble, we recommend tightening the nut firmly help if needed | seconds and turn it on again.
with а spanner. ` Peel Bucket not properly fitted. = | Make sure the peel bucket is placed —
{ correctly close to the motor housing. !
ATTENTION To avoid dry pulp accumulating between uses, thus making cleaning more PROBLEM: The appliance gets blocked frequently during extraction
complicated, pour a jug of water through the fruit input opening with the appliance } Possible cause Solution |
still running. This procedure can also be used to prevent flavours mixing when insufficient voltage. и ТҮРА УТ the voltage matches that е
processing different fruits. h indicated in the manual. i
PROBLEM: The appliance runs slowly
| Possible cause Solution !
Internal fault. Contact Technical Support Service.
PROBLEM: The appliance vibrates excessively when extracting
Possible cause Solution
|; The fruit has unbalanced the filter. Dismantle and clean the filter.
28 Instructions foruse English English Detecting Faults and problems 29