Advertisement
General Specifications
Amplifier Section
Rated Output Power
Maximum Effective Output Power
THD+N (Total Harmonic Distortion + Noise)
Input Sensitivity and Impedance
Rated RCA Output Level and Impedance
Frequency Response
Tone Control Characteristics
Signal to Noise Ratio
Supported impedance of Speakers
Headphone Rated Output
Supported impedance of Headphones
Headphones Frequency Response
North American and Taiwanese models
(North American models)
With 8 ohm loads, both channels driven, from 20 Hz-
20 kHz; rated 80 watts per channel minimum RMS
power, with no more than 0.08% total harmonic
distortion from 250 milliwatts to rated output. (FTC)
(Taiwanese models)
7 ch × 135 W at 6 ohms, 1 kHz, 1 ch driven of 1% THD
(IEC)
(North American models)
165 W at 6 ohms, 1 kHz, 1 ch driven of 10% THD
(Taiwanese models)
7 ch × 155 W at 6 ohms, 1 kHz, 1 ch driven of 10% THD
(JEITA)
0.08% (20 Hz - 20,000 Hz, Rated output power)
LINE/PRE OUT (ZONE B) : 1 V/200 mV/2.3 kΩ
10 Hz - 100 kHz/+1 dB, –3 dB (Direct/Pure Direct)
±10 dB, 20 Hz (BASS), ±10 dB, 20 kHz (TREBLE)
European, Middle East, Australian and Asian
7 ch × 135 W at 6 ohms, 1 kHz, 1 ch driven of 1% THD
(IEC)
(European models)
7 ch × 155 W at 6 ohms, 1 kHz, 1 ch driven of 10% THD
(IEC)
(Middle East, Australian and Asian models)
7 ch × 155 W at 6 ohms, 1 kHz, 1 ch driven of 10% THD
(JEITA)
200 mV/32 kΩ (LINE(RCA))
PRE OUT (SUBWOOFER) : 1 V/470 Ω
106 dB (IHF-A, LINE IN, SP OUT)
4 Ω - 16 Ω
80 mW + 80 mW (32 Ω, 1 kHz, 10% THD)
8 Ω - 600 Ω
10 Hz - 100 kHz
Appendix
models
120
Advertisement
