Mitsubishi AUM-1371A Instruction Manual page 7

__ POWER ON INDICATOR
This indicator illuminates when the power is ON.
f) POWER ON/OFF SWITCH
Press to turn the power ON
Press again to turn the power OFF
8
CONTRAST CONTROL
Rotate the control clockwise for more CONTRAST.
Adjust according to brightness at place of use and to your liking.
8
BRIGHTNESS CONTROL
Rotate the control clockwise for more BRIGHTNESS.
Adjust where to be in black in the screen to be in black.
o
MONOCHROME SWITCH
Set this switch at the Monochrome side when the unit is to be used in the Monochrome mode of
IBM® PC. Set the switch at the "Normal" position when the unit is to be used in the Color mode of
a normal personal computer.
Note: In this case, some flickering may occur because of short persistence of the CRT phosphor.
o
COLOR CONTROL (When composite Video is to be received)
Adjust to obtain the best color intensity of the picture according to your preference.
Rotate clockwise to increase color intensity and counter-clockwise to decrease color intensity.
Adjust to your preference.
o
TINT CONTROL (When composite Video is to be received)
Adjust to obtain the best flesh tones according to your preference.
Rotate clockwise to add green tint to the color tone and counter-clockwise to add red tint to the
color tone.
G
H. POSITION CONTROL (When a RGB TTL or Analog
Signal is to be received)
Adjust by this switch when positions of letters or figures in the screen are to be shifted slightly
to right or left side.
o
V. POSITION CONTROL (When a RGB TTL or Analog
Signal is to be received)
Adjust by this switch when positions of letters and figures in the screen are to be shifted slightly to
upper or lower position.
I) H. SIZE CONTROL (When a RGB TTL or Analog Signal is
to be received)
Adjust by this switch when horizontal sizes of letters or figures in the screen are to be changed.