QED LANDTEC i-Q Series Operation Manual page 41

7) Replace the pressure module, ensuring the connector on the Carrier PCB aligns with the socket on the
base of the module.
Note: Care is to be taken when aligning
8) Replace the case back and secure it in place with the retained screws and the Phillips No.1 screwdriver
9) Tighten the inlet port plate screws using the Phillips No.1 screwdriver
10) Place the replacement battery pack (QED part number PMMPB) into the case back recess. It will only fit
one way and will automatically align itself.
Figure 17 – Pressure Module Alignment
Figure 18 – Case Back Fitting
Figure 19 – Inlet Port Plate Fitting
Operation Manual
GEM and GEM PRO
OMiQGEM-L Issue.02
Page 41 of 51