Triax 2015 User Manual page 33

aligned for use. To save battery power the drop test must be performed within 15 seconds
before the LED resets to the blinking condition. The test can be restarted by rotating the
sensor away from the trigger block and then back into place.
Photo D.4 - Trigger block located above release knob
D.4 Hand Held Setup
Referring to section B.3 CONFIGURATION of the Triax 2015 user manual, set the
RELEASE to TUBE.
D.5 Performing a Drop Test
1. Using the handle, place the head form in the top of the tube. It will be prevented from
falling by a metal pin protruding into the tube about 4" down from the top.
2. Press the Triax 2015 ON key, and press the red push button on the head form.
32