Table of Contents
Advertisement
3.3.4 Finish setup
1. Click the
after setting up the event, action in the event action rule set page.
2. If everything is set up correctly, you can see the new event in the list on the Intrusion
Detection application screen.
3.3.5 Filter settings (optional)
Schedule and Combined Rule filters can be used to set up event filters to drive actions. The
schedule and Combined Rule filter settings described below are not required to configure an
action rule, so you only need to set them if necessary.
3.3.5.1 Schedule settings
Set up event action schedules that operate over a period to set the time for sending the
notification whenever an event occurs.
1. Click the
2. Add a schedule to drive action when an event occurs. Please refer to the 'Schedule
Setting Guide' for more information on how to set up a schedule.
3.3.5.2 Combined Rule condition settings
Set compound conditions on event actions to perform more complex forms of event filtering.
The following items can be set as compound conditions.
•
Rules set in the application in the form of an event action
•
Events that make up a rule are set in an application in the form of an event action
•
System I/O devices, such as alarm inputs or virtual alarm inputs
1. Click the
2. Please refer to the 'Combined Rule Setting Guide' for more information on setting up.
button at the very bottom to save intrusion detection event settings
button to set the event action schedule.
button to set the combined rule condition.
31
Advertisement
Table of Contents
