Advertisement
1
2
c
b
a
4
d
Do not clean any part of the
•
brush under tap water as it is
extremely dangerous.
For additional protection, we
•
advise you to install a residual
current device (RCD) in the
electrical circuit that supplies
the bathroom. This RCD must
have a rated residual operating
current not higher than 30mA.
Ask your installer for advice.
Burn hazard. Keep appliance
•
out of reach from young
children, particularly during use
and cool down.
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable
standards and regulations regarding exposure to
electromagnetic fields.
3
5
Recycling
-Do not throw away the appliance with the normal
household waste at the end of its life, but hand it in
an official collection point for recycling. By doing this,
you help to preserve the environment.
- Follow your country's rules for the separate collection of
electrical and electronic products. Correct disposal helps
prevent negative consequences for the environment and
human health.
2
How to use
Before use:
Note
•
Only use the brush on dry hair.
•
Bristles are hot. Do not touch the bristles nor put the
bristles too close to your hair roots or scalp, to avoid
unintended burns.
•
Some parts of the brush may be hot. Hold the product
by its handle.
•
Remove your fingers when the brush is close to hair
ends to avoid touching the bristles.
•
Do not wash the brush under running water.
Connect the plug to a power supply socket.
1
Comb your hair thoroughly and divide them into small
2
sections.
Slide the temperature switch (
) to select your desired
3
a
setting according to the table as below.
Hair Type
Temperature Setting
Thin / Medium hair
- 170℃
Thick hair
- 200℃
»
The indicator (
) will keep blinking until the appliance
b
is ready for use.
To straighten your hair ( Fig.3 )
Use a round brush or comb to detangle your hair before
1
using.
Select one section of hair and put the heated brush (
2
underneath the hair strand with bristles facing upwards,
about 3cm away from your hair roots.
Hold the selected hair section taut. Slide down the brush
3
slowly to your hair ends in a single motion and slightly
turn in the brush as you reach the ends to give soft flicks
to the ends.
Allow the section of hair to cool for 2-3 seconds. On the
4
same hair with brush facing downwards, hold the hair
taut and slowly slide down to your hair ends in a single
motion without stopping.
Repeat steps 2-4 as necessary until you get your desired
5
results.
To turn off the appliance, slide the switch (
) to O.
6
a
Let the hair sections cool down before you finger-comb
7
the hair into its final style. For long lasting results, mist
with hairspray.
Tips and Tricks
•
Flatten the selected section of hair between your fingers
before placing hair on the brush so that hair is spread
evenly across the brush.
•
Place selected hair as close as possible to the heated
base of the brush to ensure there is good contact with
hair for better styling results.
After use:
Switch off the appliance and unplug it.
1
Place it on a heat-resistant surface until it cools down.
2
Clean the appliance and bristles by damp cloth and use
3
your fingers to remove hair or dust on the brush.
Keep it in a safe and dry place, free of dust. You can also
4
hang it with the hanging loop (
).
d
3
Guarantee and service
If you need information e.g. about replacement of an
attachment or if you have a problem, please visit the Philips
website at www.philips.com/support or contact the Philips
Consumer Care Center in your country.The phone number is
in the worldwide guarantee leaflet. If there is no Consumer
Care Centre in your country, go to your local Philips dealer.
4
Troubleshooting
Problem
Cause
Solution
The
The power socket
Check the appliance is
appliance
to which the
plugged in correctly.
does not
appliance has been
Check the fuse for this
work at all.
connected may be
power socket in your
broken.
home.
The hair
Temperature setting
Brush your hair when
strand is
is too low to reach
the indicator stops
not straight
the desired style.
blinking.
enough
Change temperature
after
setting to .
styling.
Put the selected hair
strand close to the
heating base of the
brush.
)
c
Advertisement
