EdenPURE Classic EPWSIHCL Startup Manual

EdenPURE

Operating Instructions

1. Plug the power supply cord into a grounded wall outlet. (120VAC,
60Hz)
Important: This heater is for use on 120 volts. This heater comes with a
grounded (three-prong) plug. The grounded plug must be used with a
grounded outlet. Do not use an adapter in a two-slot wall outlet.

2. TURNING THE HEATER ON

To turn the heater ON, press the MODE button, the heater will wait in ECO
Mode.

3. HEATING MODES

Press the MODE button to toggle between the different modes: ECO, HIGH,
LOW and STANDBY. Exit from any mode to stand-by mode by pressing the
STANDBY button.
4. ECO MODE – 1500W/1000W
ECO mode is a computerized mode to optimize energy efficiency. It will
programmatically select between HIGH and LOW power mode to heat up the
room to the desired temperature in the most effective way. Once the desired
temperature is achieved, the heater will maintain the room to the set
temperature. ECO mode is the environmental friendly operating mode.
5. HIGH POWER MODE – 1500W
HIGH mode will control the heater to operate at high power until the room
reached the set temperature. The heater will stop heating and initiate
component cooling process before turning off the fan. Once the desired
temperature is achieved, the heater will maintain the room to the set
temperature.
6. LOW POWER MODE – 1000W
LOW mode will control the heater to operate at low power until the room
reached the set temperature. The heater will stop heating and initiate
component cooling process before turning off the fan. Once the desired
temperature is achieved, the heater will maintain the room to the set
temperature.
CONTINUES ON REVERSE SIDE
Classic Heater
®
EASY START-UP GUIDE