Advertisement
HOW TO
Do regular maintenance on the LGX® PRO and LGX® PRO 2.85
07
Lift the needle bearings out with your 2 mm hex
key.
10
Wipe off excess grease and solvent from the
stepper motor. Brush the rest away.
13
Wipe off excess grease and solvent from the
needle bearings. Be careful to not loose needles.
www.bondtech.se
08
Place the double gear, drive gears and needle
bearings in a small container and fill up with IPA.
11
Wipe off excess grease and solvent from the
double gear. Brush the rest away.
14
Apply a generous amount of grease to the motor
gear.
09
Let the parts soak for about 10 minutes.
12
Wipe off excess grease and solvent from the
stepper motor. Brush the rest away.
15
Next, place the needle bearings on the drivegear
pins and apply grease.
Page 3/8
Advertisement
