Table of Contents
Advertisement
OPERATING PROCEDURES:
7.
STARTING THE GENERATOR ENGINE FOR THE GP8000IS:
Turn the Fuel Saving switch to "OFF" position.
7.1.1.
Turn the Air Knob on the Fuel Tank to the "On" position.
7.1.2.
7.1.3
Open the Fuel Choke.
Turn the Combined Switch to "Start" position.
7.1.4.
7.1.5.
Press & hold the "Start Button" for 4 seconds and wait for the
generator to start.
7.1.6.
To manual start pull the Recoil Starter until resistance is felt.
7.1.7.
Do not pull the rope of the recoil starter out completely.
7.1.7.
After starting the generator allow the engine to warm up and rotate
the Combination Switch to the "Run" position.
7.1.7.
After starting the engine successfully, press the fuel-saveing switch
in the "On" position.
*NOTE: When pulling the hand starter, grasp the handle to prevent the generator
from falling down.
*NOTE: If you are starting the generator for the first time, we recommend that you
use the recoil starter.
When the ambient temperature is lower than 0°C (32°F), the engine speed is 4100rpm and the
A.
warm-up time is 3min.
When the ambient temperature is below -5°C (41°F), the engine speed is 4100rpm and the warm-up
B.
time is 3min.
After the above operation time, the fuel saving switch can work normally in "ON" position.
C.
WARNING
Do not move the generator while it is running.
Be sure to ground the generator if the connected appliance is grounded.
Failure to ground the unit may lead to electrical shock.
10
Advertisement
Table of Contents
