Installation - Gentech GP8000IS Operator's Manual

Pure sine wave digital inverter generator
Table of Contents

Advertisement

FUEL CAPACITY FOR THE GP8000IS GENERATOR:
6.5.
6.5.1
GP8000IS - 26L
Make sure you review each warning in order to prevent fire hazards. Do not refill the fuel tank
whilst the engine is running or hot. Please ensure that the fuel cock is closed before refueling.
Be careful not to contaminate the fuel with any dust, dirt, water, or other foreign liquids/objects.
Please lean all spilt fuel thoroughly before starting the generator. Ensure that the generator is
clear from any open flames. Do not smoke whist refueling the generator.
CHECKING COMPONENT PARTS:
6.6.
Before starting the generator, please check the following:
Check for any fuel leaking from any part of the generator.
6.6.2.
Check that all the nuts and bolts are securely tightened on the generator.
6.6.3.
Check for any visible damaged components on the generator.
6.6.4.
Check that the generator is not resting on or adjacent to any electrical wiring.
6.6.5.
CHECK THE GENERATOR SURROUNDINGS:
6.7.
WARNING
Make sure you review each warning in order to prevent fire hazards. Keep the surrounding
area clear of flammables or other hazardous materials. Keep the generator at least 3 feet
(1 meter) away from all buildings and or other structures. Only operate the generator in a dry,
well-ventilated area. Keep the exhaust pipe clear of all foreign objects. Keep the generator
away from open flames. Do not smoke near the generator. Keep the generator on a flat and
level surface. Do not attempt to block the generator air vents with any paper or other
material/objects
LEAD ACID BATTERY OPERATION FOR THE GP8000IS:
6.8.
The recommended battery capacity is a 14 Amp Hour.
Health Warning:
The electrolyte inside the battery is harmful to skin and eyes. If the battery leaks and the
electrolyte get into your eyes, do not rub them. Instead, rinse them with clean running water
and immediately seek medical attention. If left untreated, electrolyte can cause permanent
injury to your eyes.

Installation:

Check the battery voltage with a voltmeter before fitting. If the voltage is less than
Ÿ
12.8 Volts, do a refresh charge (see charging section).
7

Advertisement

Table of Contents
loading

Table of Contents